![]() Rawhide is the duct tape of the old west - I understand that the Mormon Tabernacle in Salt Lake City was put together with wooden pegs and rawhide strapping. After it's completely dry seal it with something like spar varnish or a non-gloss woodfinish.įigure it might give you some ideas.when using the tacks - predrill part way and cut off the sharp tip to prevent splitting and like TW said glue and then wrap the rawhide. I use the baseball stitch to sew it all together and then tap the seam flat while damp. Apply a few liberal coats of linseed or Tung oil to all the wood surfaces in these areas, especially the open pores of end grain. If you're going to use tacks adda couple to hold teh hide in place and then trim to fit real close - a LITTLE gap in between is good, you want to pullit up real tight as you sew. Your stock will need to be shipped to Sheboygan, Wisconsin so please call me for the shipping address and. I also used reinforcing brass rods that were available from Brownells. It will leave a glue line but any glue will leave a line. It is the strongest glue for wood that there is. Note: Complete guns cannot be shipped to me due to Federal regulations, only stocks may be shipped. When I was a stock maker I always used West Systems epoxy. Any gun stock repair including nicks, scratches, cracks or complete breaks are one low price which includes the return shipping back to you. Soak it until completely saturated (may take several hours) and then let set until the excess moisture is gone. CALL FOR QUOTE: My cell number is (920) 627-8450. FWIW - I much prefer deer elk or deer rawhide over cow - has all kinds and good prices - buy a small damaged one for cheap and you'll still have a good bit of usable material. Winchester Model 88 Replacement Stock SKU W88F Review this product 340. Just finished this set up for a gent - aged the wood and then added a bit of deco - the buttstock was 'repaired" with deer rawhide and the forend with braintan - I used BT since I didn't have the whole gun and was concerned with cracking the fore end if I used rawhide - it can impart a lot of pressure and or pull. Winchester Sight Hood Guide to Vintage Gun Parts Winchester Sight Hood Thanks.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |